JCC-MX Key Cap 30mm

The JCC-MX key cap was designed (by Jasen) and manufactured in the United States. We partnered with a long time customer (and proud Panzer Fight Stick owner) at ArkPlas to take our key cap design for the Panzer Fight Stick MX series of panels from a novel 3D printed test piece to a properly manufactured, injection molded part.  The process was long but the final fit and finish is amazing because of the attention to detail along the entire journey to get here.

NOTE: These are shown with SANWA LB-35 BALL TOPS (where appropriate) and 24mm MX caps of equivalent color for illustrative purposes only. You only get ONE cap per ONE you add to your cart.

Our caps fit into 30mm openings with minimal gap all the way around. Intentionally designed for the Panzer Fight Stick 5 series of cases, if the opening is sized properly they can fit any MX style switch. They are designed to the Cherry MX published standard.

They are intentionally rounded on the edges to allow for fast slides between buttons and flat on top so you can feel exactly when you hit the "sweet spot" of the cap.  Additionally, the body of our caps extend down to the same spot as the stem connector so you have a more finished looking install.

Dimensions:  ~29mm diameter, ~6mm tall

Comparison between the JCC-MX and similar caps previously recommended:

• Thicker walls
• Only 2 grab points for mx cap pullers
• ABS Plastic
• Solid Color (for now)
• Taller