Category_Panzer Fight Stick

IPFB on the Panzer Fight Stick 3/3i

A new question that has popped up recently is whether or not the Integrated Pico Fighting Board (IPFB) is compatible with the Panzer Fight Stick 3. In sort, yes it is with some caveats.

  1. The IPFB does not have a DP, LS, RS connection like the Brook PCBs where you can shift your lever between the modes – you won’t connect this up when installing the IPFB and therefore the three way toggle switch will not do anything if you change it’s position. The Panzer will just operate in D-PAD mode.
  2. The IPFB uses side entry PH connectors for the L3/R3/TP connector and the other connectors. You can connect the EZ BUILD systems wiring to these instead of a vertical connector, but it might be tight. You should consider swapping the side entry type for a vertical connector instead.
  3. The IPFB does follow the standard PS360+ and BROOK PCB mechanicals – it will fit fine in the chassis.

Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

More from: Category_Panzer Fight Stick
Back to Blog

Explore more

Share this