TE EZ MOD Install Notes: Jumpers and Slider Switches!

The TE EZ MOD is a rather painless install. There are a couple minor tweaks you need to do though.

  1. Cut the SJ2 or SJ3 jumper with an exacto-knife depending on your home panel situation. See the graphic below for which to cut.
  2. Trim the actuators on the slide switches with some flush cut snips. You only need to trim a small amount so the covers fit on it and allow the PCB to screw down properly. Sneak up on the cut carefully!


Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.