The SOCD Kit is not difficult to install, but there are a few things you need to know in order to be successful.

1. The existing JLF plugs into the JST SHF connector on the PCB. No modifications needed.

2. The PCB has to be powered. If its not - it will not work.

3. To use the USB Power Snatcher, you need to cut, strip back and splice into your fight stick's USB cable. This is the most difficult and likely spot to create a problem. Go slow, give yourself enough room and connect the wires up per the PCB labels. Note: the GND and SHIELD are not connected on the USB Power Snatcher PCB. This was intentional to ensure unique USB cables were accommodated. Do not strip more wire than needed, keep them as short as possible.