This Panzer Fight Stick Unibody is all machined aluminum with the exception of the carbon fiber inlaid top. The aluminum is bead blasted and anodized for a great finish; similar to all of our aluminum dress up parts. Because its milled from a single block of aluminum, there are no fasteners to see, weak points, or bends.

NOTE: Images are RENDERS ONLY. This is a PRE-ORDER while these are manufactured. If you know JasensCustoms.com - you know these will be delivered on schedule with a lot of communication!

The design was purposely kept simple - to stay in line with the Panzer design aesthetic developed over the years. Hardware to fasten the top and bottom panel to the main body is countersunk for a clean look. The Neutrik Port is counter sunk so you don't need an additional surround. All Aux buttons are located on the front of the case, similar to the Panzer 2.0 and Panzer 3/3i. There are no hard edges once assembled - every edge has a gentle curve. 

You should plan on using screw in buttons for this case - in all locations. The top panel is 5mm thick when everything as attached. The case is 3mm thick for rigidity - except in the corners where they are larger for support.

There is a mounting point for your PCB on the top panel - it works with the IPFB and any Brook Fighting Board.

Since the Neutrik is counter sunk into the case and there is a support above and below it - you will need to use a straight connected USB cable for both ends.

This is a limited run of 10 cases.  All 10 are in production and expected to be ready within 30-45 days. Machining takes time.

Includes: Main body, upper and lower panes, carbon fiber inlay, 4x rubber feet, and mounting hardware for the Neutrik (or my USB C connector), and Brook PCB.

Wiring will be required. EZ WIRING kits will work when coupled with the aux board ez wiring and may be offered separately.